Maintenance of equipment

A: Choose poorly and you’ll see mis-tracked pallets, emergency stops, and a line-down call from Prod during peak shift. Chain wear is managed, not ignored, by matching lube and tensioning to real cycle counts.

A: Miss this and you risk an arc-flash event that shuts down a substation and triggers an MOC review nobody wants. Partial discharge often shows up as heat and surface damage long before protection trips.

A: Get this wrong and you’ll coke the oil, seize the turbo, and eat downtime plus warranty fights. Heat soak after shutdown is the real killer in stop-start service.

A: Ignore trending and you’ll get a ground fault that trips protection and stalls a critical load. Winding failures develop over time, and IR/PI trends tell the story early.

A: Skip cleanliness and you’ll be chasing erratic press behavior and scrapping parts on the next shift. Small dirt equals big hydraulic problems.

A: Miss water chemistry and you’ll rupture a tube, forcing an unplanned outage and regulatory reporting. Deposits form quietly until failure is sudden.

A: Rely on alarms only and you’ll react too late, often during peak load. Trends buy you planning time instead of firefighting.

A: Get this wrong and you’re facing a fire event, site evacuation, and a long shutdown. Thermal issues show up as cooling or imbalance problems before the BMS screams.

A: Ignore leaks and you’ll burn power nonstop, driving up utility costs and stressing compressors. Leaks are silent budget killers.